Setseal 6 has been designed to overcome the drawbacks of many commonly used curing membranes which tend to provide a limited service life following the curing period of new concrete. It has good abrasion resistance and can be coated with certain coatings (please contact our Technical Department for specific applications).
25 litres and 200 litres.
5 - 12m² per litre per coat depending on the absorbency of the base.
Store in closed containers above freezing (0°C) under dry, wellventilated warehouse conditions out of direct sunlight and away from naked flames or other sources of ignition.
At least 12 months if stored in original containers.
Setseal 6 should be applied immediately following power floating/finishing of the concrete surface ensuring all excess surface water has evaporated prior to application of the Setseal 6.
All surfaces must be clean, dry and free from oil and other such contaminants.
Stir the Setseal 6 before use.
Apply Setseal 6 by fine spray at a rate of 5 to 12 m² per litre. In severe drying conditions a second coat should be applied after 2 to 3 hours. Care should be taken to ensure complete coverage.
Apply Setseal 6 by squeegee, brush, spray or broom at a nominal rate of 5 to 10 m² per litre for the first coat, followed 5 to 8 hours afterwards by a second coat of 10 to 12 m² per litre.
As the condition and therefore the porosity of concrete surfaces can differ so widely, it is recommended that a test application area be carried out to determine the precise coverage rate for each specific job.
All equipment and tools should be cleaned thoroughly with Xylene and allowed to dry.
Please contact our Technical Department for specific applications.
Application range 5°C to 30°C.
Do not apply in external situations where rain is likely to come into contact with the uncured Setseal 6.
HEALTH AND SAFETY
Consult the appropriate Material Safety Data Sheet before using Setseal 6.
This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department.