Gripdeck PRIMECOAT
Previous product
Next product
Gripdeck FLEXCOAT
 

Gripdeck
PRIMECOAT E

SOLVENT FREE EPOXY RESIN PRIMER
 
Description:

Gripdeck Primecoat E is a 2 part solvent free epoxy primer formulated for easy application by squeegee, roller or brush to concrete and screed substrates prior to overcoating with Gripdeck Wearcoat or Gripdeck Flexcoat.

Usage

Gripdeck Primecoat E is designed to give excellent adhesion to both the substrate to which it is applied and the subsequent Gripdeck Flexcoat coating.

Materials Supplied

5kg and 20kg. 

Coverage

The coverage will vary depending on the texture of the surface to which the Gripdeck Primecoat E is applied. As a guide, the coverage is approximately 0.4kg/m² depending on the above and the requirements of the specification.

Storage

Store under dry warehouse conditions at temperatures between 10°C and 30°C.

Shelf Life

12 months if unopened, undamaged,

Technical Information

Working time @ 20°C20 minutes
Tack free time @ 20°C12 hours
Maximum overcoating time at 20°C30 hours
Adhesion to concrete (N/mm²)
> 1.0
(Substrate Failure)
Application Temperature Range
10 to 30°C
(do not apply if
the ambient or
floor temperature
is to fall below
10°C during the
first 24 hours)
Hardness (Shore D)80
Volume solids (%)100

Application Instructions

SURFACE PREPARATION

For details please see the DCP Guide to Surface Preparation. The surface should be clean, dry and free from dust, laitance, oils, paints or other forms of contamination.

MIXING 

Gripdeck Primecoat E comprises two components, a Resin Base and Hardener which are supplied pre-weighed in the correct proportions. Under no circumstances should part mixing be carried out.

Taking care to ensure that the bottom and sides are thoroughly drained, pour the contents of the hardener portion into the resin container. Using a power whisk attached to a slow speed electric drill, mix for approximately 2 minutes followed by scraping down and re-mixing for a further 1 minute avoiding the entraining of excessive air until a uniform consistency is obtained and allow to stand for 1 minute. The addition of a dry fine sand may be added at this stage to help smooth the substrate.

Never mix Gripdeck Primecoat E by hand as this could lead to areas of uncured material.

APPLICATION

Once mixing is complete, spread the Gripdeck Primecoat E onto the floor using a squeegee and short / medium pile roller, ensuring it is worked well into the surface.

Gripdeck Flexcoat should be applied to the cured Gripdeck Primecoat E, this should be undertaken within 30 hours of application.

CLEANING

Tools should be cleaned with solvent immediately after use.

HEALTH AND SAFETY

Consult the appropriate Material Safety Data Sheets prior to using Gripdeck Primecoat E.

GENERAL GUIDANCE
This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department.


Download file



Related products





Connect with Don Construction Products


  Complaints Record Form

  Customer Satisfaction

Name *
Email *
Phone
Address
Subject
Request  
Security Code *

Don Construction Products Ltd.

Headquarters
Hawthorn House, Helions Bumpstead Road,
Haverhill CB9 7AA, United Kingdom;
Tel: +44 1 4407 66360 
Fax: +44 1 4407 68897

Email: sara.harvey@dcp-int.co.uk
Email: stephen.bird@dcp-int.co.uk