Gripdeck Primecoat can also be used as a Body Coat on top of Gripdeck Flexcoat prior to blinding with the appropriate grade of aggregate and finishing with Gripdeck Wearcoats.
For all external applications where Gripdeck Flexcoat is to be applied, Gripdeck Primecoat E should be used.
5kg and 20kg.
Gripdeck Primecoat can also be used as a Body Coat on top of Gripdeck Flexcoat prior to blinding with the appropriate grade of aggregate and finishing with Gripdeck Wearcoats. For all external applications where Gripdeck Flexcoat is to be applied, Gripdeck Primecoat E should be used.
Store under dry warehouse conditions at temperatures between 10°C and 30°C.
12 months if unopened, undamaged, sealed containers and stored under good conditions.
For details please see the DCP Guide to Surface Preparation. For new build applications or where the relative humidity of the floor exceeds 75% measured using a suitably calibrated hygrometer, Strongcoat DPM should be used, prior to applying Gripdeck Primecoat.
Gripdeck Primecoat comprises three components, a Resin Base and Hardener which are supplied preweighed in the correct proportions along with a bag of filler for use where a greater depth is required. Under no circumstances should part mixing be carried out.
Taking care to ensure that the bottom and sides are thoroughly drained, pour the contents of the hardener portion into the resin container. Using a power whisk attached to a slow speed electric drill, mix for approximately 2 minutes followed by scraping down and re-mixing for a further 1 minute avoiding the entraining of excessive air until a uniform consistency is obtained and allow to stand for 1 minute. If the filler portion is to be used, add the contents of the filler into the mixed material and mix for a further 1 minute.
Never mix Gripdeck Primecoat by hand as this could lead to areas of uncured material.
Once mixing is complete, spread the Gripdeck Primecoat onto the floor using a squeegee and short / medium pile roller, ensuring it is worked well into the surface. Then blind with the appropriate grade of Gripdeck or Quartz Aggregate and allow to dry.
Tools should be cleaned with a suitable solvent immediately after use.
Gripdeck Wearcoat / Plus/ TG may be applied as soon as the blinded Gripdeck Primecoat becomes tack free.
USE AS A BODY COAT
Gripdeck Primecoat may also be used as a body coat on top of Gripdeck Flexcoat. When being used for this purpose, the resin and hardener parts should be mixed together and applied at a minimum rate of 1.0kg/m², this may then be blinded with Quartz or Gripdeck Aggregate prior to drying and application of the final wear surface.
HEALTH AND SAFETY
Consult the appropriate Material Safety Data Sheets prior to using Gripdeck Primecoat.
This data sheet is for general guidance purposes only and may contain information that is inappropriate for certain conditions of use. Accordingly, all recommendations and suggestions are made without guarantee. Further information is available from our Technical Department.